Recent content by Buckshot

Just eat two at a time. Frozen.

Lol. HUGE sealed boxes mean NO significant power handling. And loose the whole top end of bass sprectrum. Lol. Cut it right straight down the middle, and put two subs in half that box. Give power and rock it.

Does the car your doing have the upgarded sound or climate control? If so your starting a fight lol. The wires you would have to run to the trunk should be to hook up your 5k amp and and an 18. Other than that I dunno.... I do however know the ones with climate control have all the controls...

Well, you had engine noise. You grounded the RCA's and started burning them up. I personally would get a new set of RCA's and just run them to the amp and see if it solves your problems. Almost like you have a short somewhhere. Don't even install them all the way, just hook up both ends and see...

Here Comes THE BIGGEST comeback in NFLs superbowl History. Down by 13, arizonas gonna make a BIG upset.

Oh dont worry I know the key word here...

well in that case its the last digits are nine. A 100 yard ****in touchdown! ****. Sorry that could have been a good chunk of my new components.

If that steelers touchdown wouldnt have went, ida' won 50 for my square. Soma'bish.

Dual and explodes ftmfw! DOesnt look too bad 'atall...

2 minutes from OP and you had a signature and some money !

Dial has to be straight down. Touch the leads together, does it read zero? Touch the leads to one of the 4 voice coils, does it read 2 ohms? If so finish your leads and jumpers and test the single pos and neg going to the amp. I hope you aren't trying to test this with everything hooked up...

If its leaking ATF (automatic ***** fluid) it aint the rear main. I dont know if you just said that wrong or what, but it probably needs a converter a FRONT seal in the ***** and a bushing in the pump... But wtf do I know?

I think fiberglass is sha-weeet. That what your doin next?

What if it's gotta go left? We need left angles too?

If you say so. Cabinet grade, and highend high dollar ply is very good, but standard pine/fur ply...