Recent content by bradch

I'm not expecting too much. The sub is literally not moving. I went and troubleshooted with a local car shop and my RCAs or RCA inputs on my head unit have gone bad in the period my system was not hooked up.

Anyone?

Thanks. I was wondering if I was supposed to bridge the two channels on the amp because that's the only other thing I can think of.

Why is there two positives and two negatives for speaker inputs on the back of my amp if it's a monoblock?

I just tried unplugging each RCA individually and nothing happened. I even tried to do the same thing switching them around.

All of my speaker wire connections look great. I will try to unplug one of the RCA's now. I remember it sounding different when I did that to reverse them last night, but the volume was at a low setting. I do not know what the converter is.

I have a single American Bass XFL 1244 and an American Bass VFL-Hybrid 4480.1D. I want to get a 2 ohm load. Here is a video of what I have set up now. The subwoofer almost gets no movement with this. The amp turns on. What am I doing wrong? What do I have wrong? - YouTube

I did that as well.

I did it exactly like that which is what confuses me.

I have an XFL1244 and a VFL Hyrbrid 4480.1D mini and I want to wire to a 2 ohm load. ] There are 2 negatives and 2 positive on the back of the amp and I have the sub wired up in my box. I went first negative to first positive and it sounds the best there but not at all like it should. What am I...

I finally got my American Bass XFL 1244 and VFL4480.1D mini! I was going to have a kerf ported box built for me @ around 2 cubes. I have been going back and forth for 2 weeks with the only local shop around here for miles and they have good work, but terrible customer service. Therefore, I...

What would that look like?

2000 Silverado ext cab

What size diameter for the pipe to make the port? 4 inches? & Where do I place the port on the box? In a corner?

I want to get down to 32hz. How do I go about building an aero port? I am willing to increase the dimensions to say 16x19x20 or even 18x19x20. Could that bring me more towards 2.5 cubes?