Recent content by bondj0007

yes i was thinking of doing it seperate which will avoid direct impact on the amp from being directly fixed with the box. but regarding thieves it was for that thing that i was gonna do it fixed with d enclosure, since there are some days (places) where i will remove it and it will be easy for...

hi guys i was thinking whether fixing an amplifier to the box/enclosure of an amplifier, is it a bad thing since the amp will have all those vibrations to it??? i saw it done many times but had a doubt if it is bad. thanks

pls anyone?

i was thinking of wiring them as follows if i get 2 dual-2ohm subs: using GTO601 the 2 subs connected series parallel and obtain 2ohms and therefore the amp will give the 580w together. or using PX300.4, ill connect each sub at 4ohm and giving each 358W at 4ohms each sub. What would be the...

dual 2ohm voice coil (1 or 4ohms final impedance)

hi, i have a dilemma choosing an amp between 3 JBL amps. For now i will be powering 1 x 12" sub Pioneer 400WRMS, but i will make my choice so that it will allow me some way to expand (ie add a second sub). the choice is between: JBL PX600.2 @4ohms: 150WRMSx2, 600RMSx1 @2ohms: 300rmsx2 Jbl...

therefore if i do the port in the following 2 types, will it be tuned the same provided that the length & area is in both ports the same?? or should i tune according the port type...

if the length of port decided is longer than the box depth, will folding the port in a zig-zag form, be the same as doing it in form of slot port of same length as if it is a folded one??? thanks

thanks all for the info ill go with bigger port for my box as you suggested, and then i tune it to 31Hz through port length cheers

sub: http://www.pioneer.eu/eur/products/25/130/201/TS-W307D2/index.html Amp: http://www.kenwood-electronics.co.uk/products/car/amplifiers/KAC-6203/details/ WHAT I WANT TO KNOW IS HOW YOU CALCULATE A PORT AREA FOR A SPECIFIC VOLUME?? i.e. how you say its a bit small??? if i increase port area...

what i dont understand is: if i find a port size that using that size my box adequately tunes to the wanted frequency, is that a correct size??? or that size could be small or big, according to my box volume independantly from what i am tuning???

it is a 12 inch pioneer but what is the ideal port area for my box?? if i know the area then i can find the length easily

tuning to 31Hz

someone please guide me

that link you gave me is for Round ports and also you need to know the port size before hand! i need something that CALCULATES THE PORT AREA BASE ON THE BOX VOLUME???!