Recent content by BKH

I would cut the studs down and get some polished acorn nuts.

IMO, Those tundras need something bigger than a 20...It's a big arse truck. At least go with a 22 and some 305's.

They don't have to blow directly on the amps. I built a plexi covered amp rack for a Camaro with fans in one end and an intake on the other. Worked great. Just some circulation is all you need.

Yea, 3500+ posts in 3 months, he must have a lot going on.

Drove both before deciding on the Toyota. The Nissan has a STUD of a motor (the 4.0), but the Taco is a bigger truck, inside and out, and I just thought it looked better. I think you can get the Nissan a little cheaper though.

Thanks for the comments! Sounds great! Not loud enough though..... Yea there is a crossmember across the back wall thats a PITA .

More, hit the box with a few coats of filler/primer, sanded with a DA, and painted with Duplicolor spray bedliner. Matched the factory color and texture pretty good. Excuse the blue wire loom, will get techflex soon...

Decided to throw a little something together in my 08 Taco doublecab, 2 RE-8's, Punch 300-1, Pioneer 4900, Tsunami wiring, dist. blocks and fuse holder with volt meter. In the near future I will add some 6.5" component sets in the front doors powered with a Linear Power 992iq, some 6.5"...

Well I did some figuring and the people that built the box were way off on the advertised volume of the box I bought. I have only about .38 per chamber (thought it looked small) So I'm going with 2-8's. Now I gotta figure out if it's possible to wire 4-4ohm voice coils to get around 2 ohms.

About made my mind up to do 4-RE 8's in my Tacoma. The box is about 1.3 cubes total, sealed, and I have a Punch 300-1. Only have about 4.25 inches of depth. I searched the forums and found lots of info on ported installs but would they bang pretty good in a sealed box?

In my Tacoma 4 Door, I had 15% put over the factory tint in the rear and 5% in the front doors. Matches perfect. Kinda hard to back up at night but NICE in the daytime.

Few more

Cool! I have a few pics of some stuff I had back in the early 90's, I guess thats old school. I have lots more I'll try to dig up and scan. I was 16-17 when these were done. Same truck, evolution of the system. I remember my dad about sh!t when I took the sawsall to the cab LOL.