Recent content by Big Dee

Active would be picking ALL of the x-over frequencies for the speakers. This includes a bandpass filter for the mids and a high pass for the highs. This will involve at least four channels of amplification if you're running a 2-way component setup.

I love my table saw. Routers are fun too.

I have 2 or 3 ring terminals that I don't need at all. You can have them for free, PM me your address and I'll send them soon.

Great tips xtremekustomz. Thanks a bunch.

I'm using clear over the base though.

I've seen it said on here many times to sand the paint before applying clear, but I read an article on car painting that said that you should only sand the primer and the clearcoat and not the basecoat color. What the dealy yo?

AGU fuses can be found in 120 A sizes I believe. You fuse to the wire, so assuming you're using 4 gauge wire after the D-block I would get some 120 or 100amp fuses and call it a day.

Not to mention the fact that he's telling every thief in the area that he has some amps to take.

Reading > all of us

If that amp can run stable at .7 ohms which is what it would be around after impedance rise, then yes, you will see a big increase in SPL and also SQ since you can run it at the same levels as before but with less distortion.

Table vice has always worked well for me.

http://www.caraudio.com/forum/showthread.php?t=187444&highlight=gorilla+glue+wood http://www.caraudio.com/forum/showthread.php?t=183470&highlight=gorilla+glue+wood http://www.caraudio.com/forum/showthread.php?t=174024&highlight=gorilla+glue+wood...

Bigger drill bit is needed probably and countersinking. Any hardware store will have them. IIRC they are around $15-30 for the cheap ones depending on the length. Nothing except glue and clamps. Here is my progress so far. You can see the router accident on the port. That is filled with wood...

A box can be good looking no matter what it's for. Sorry for the lack of updates guys. My computer is down and I need to reinstall Windows. It's almost done though. I rounded all of the corners and just need to cut the hole for the sub and paint at least one side. This whole box is just to...