Recent content by ballenm04

wow, this site sux and i do have to say that everyone here is full of themselves. I come here for help, as do many other people and all i get is a ton of ******** trying to prove themselves better than everyone else. Honestly I don't care who is smarter than who. All that I want to know is the...

another thing that you can do is run regulator from RadioShack item number 276-1770 in your remote wire and that should also solve the problem.

sorry about this second thread, i tried to post it and it didn't show then I tried again and they both showed. Please go to http://www.caraudio.com/forum/showthread.php?t=194899

reguardless to needing or not needing to deaden the doors, (Why deaden if I don't get a rattle) what the hell is making my subs cut out after they get a decent amount of signal to them. Could it be that I have a bad ground. I am using a common ground for everything. Should I change that and give...

Yeah so I did wire them like this and what do you know it sounded like crap telling me that I should not have wired them like so. Secondly, I had to get a cap because if I were to turn up the level to the speakers it all would kill, lights would dim and all of that good natured stuff that lets...

They were originally run as each vc to its own channel. Also I originally had them at 4ohm, when we put power to them they rattled. I had the problem before so I changed the wiring to 2ohm and they are clear. The only problem is that they cut out when they get a decent load. After doing some...

I need as much help as i can get from you guys. I have taken my boss' 2006 mustang and installed a system into it. he originally had the shaker 500 system in it. He made an LCD monitor for it and also a carputer for it. We bypassed all the factory system. I replaced the component speakers with...

I need as much help as i can get from you guys. I have taken my boss' 2006 mustang and installed a system into it. he originally had the shaker 500 system in it. He made an LCD monitor for it and also a carputer for it. We bypassed all the factory system. I replaced the component speakers with...

Many of times I have had to send the wire through the firewall where there is already wires going through, I have fond on many cars that are made more for the teenage type, there are pre-drilled holes with sealed grommets already in place. This is usually under a wheel-well. I have a 04 honda...

The sub says a 1.3ohm i think I can't remember. Does anyone have a diagram of what the wiring is for 2ohms? I looked all over and the best help was crutchfield. the best that I could find that I thought would work is the 4ohm diagram. all others were at 1 and 8.

I am putting my buddies factory shaker 500 subs (8") for his mustang on a 250w alpine amp. the subs are 1.something ohms, the amp is a 2 ohms. Would it sound right if i hooked them up at 4 ohms? any advice would be greatly appreciated. Thanks ballem04

I just bought an 5 gb mp3 player. I am trying to hook it up to my aux channel on my 740 premier deck. I thought that it would be a simple plug and play but I plug it in and go to the aux channel and nothing comes out. The mp3's volume is up and I just do not know what the problem is. Does anyone...

I know what the difference between series and parrallel are but what is the difference in the sound quality and does one have a benefit over the other? Could someone please explain this to me. thanks.

WEll here is the deal we hooked it up to my 600w with the power all the way down then slowly turned it up so we would not overpower them too quickly. When the amp was turned up to less than 1/3 of its potential the speakers started to hop and put out a bad rattle.vThe amp was just overpowered we...

Re: Volfenhag ZX-4710 what???