Recent content by ampageg2

  1. ampageg2

    Need help with final decision (Sundown or SoundQubed)

    Been in contact with the enclosure guy and he's got the dimensions setup for my car. I drive a Ford Focus so it's a bit difficult to get the space requirements really needed. The trunk opening isn't as big as I'd like.
  2. ampageg2

    Need help with final decision (Sundown or SoundQubed)

    I'm getting a custom box made up by a friend so not worried about box. Will be ported most likely.
  3. ampageg2

    Need help with final decision (Sundown or SoundQubed)

    I've seen several of these Sundown vs. SoundQubed threads already but nothing exactly what I'm looking for. Basically I'm going to be running two 12" subwoofers off a 950W Helix amp running at 1Ω. I listen to electronic and rap. I narrowed my decision down between the: 2 x SoundQubed HDS212...
  4. ampageg2

    Help choosing sub in my price range

    Okay great thanks! I'd read that Nakamichi was good but all of the threads I found were made around 2003 or before so I wasn't sure. Thanks again. Ampage
  5. ampageg2

    Help choosing sub in my price range

    Btw I figured I'd ask here instead of starting a new thread. I found a Nakamichi and a Helix in my price range. What would you all recommend between these two amplifiers?
  6. ampageg2

    Help choosing sub in my price range

    I'm going to attempt custom ported. I had a custom vented my first time and it got really loud but got way too hot. Been using the Rockford Fosgate setup ever since.
  7. ampageg2

    Help choosing sub in my price range

    Well I currently have a friend who owes me so I'm planning on recruiting him for the project. He had access to that. I had been running two RF subs in a sealed box but someone broke into my car and made off with my amp... so I figured I'd just start fresh.
  8. ampageg2

    Help choosing sub in my price range

    Hi all. I'm currently looking for two 12" subwoofers. Budget around $200 give or take. I don't currently have an amplifier so I'm not worried about matching it up, though I'd probably prefer 4 Ohm. I've found the three below which look promising but I'm open to suggestions too. I'd like to keep...
  9. ampageg2

    Problem with power

    Finally got the time and money to purchase and install a new amp. I hooked it up today and it seemed to play for a few seconds and stopped again. Checked the voltages and at the amp I'm reading 7.5V going to the amp ground and 14V grounded to bare metal from the chassis. I don't see how I've...
  10. ampageg2

    Problem with power

    I'll replace the fuse tonight, already redid the connections on the battery. I haven't done a full pinch check but it is getting full power at both ends so I don't think that's the issue.
  11. ampageg2

    Problem with power

    No help?
  12. ampageg2

    Problem with power

    Hi all, I have a 300W Rockford Fosgate P3001 driving a pair of Rockford Fosgate 12" subwoofers. The amp is running them at 300W at 2Ω and has been working with them for quite some time. While listening to music one day the bass just kind of dropped off (no loud popping or anything like what...
  13. ampageg2

    Rumble from subwoofer and amp recovery mode

    Took it to a local shop and they said it was a bad amplifier. I replaced the amp and it wasn't going into recovery mode like the old one, but whenever the bass should've been channeling through, the LED would flash red signaling recovery. I figured it was also (assuming the amp was bad to begin...
  14. ampageg2

    Rumble from subwoofer and amp recovery mode

    How do you use a multimeter for that? I know how to use it, just not what to check.
  15. ampageg2

    Rumble from subwoofer and amp recovery mode

    Hi everyone, first post here, so hopefully this fine community can give me the answers I'm looking for. I currently have an entry level sound system and have been having some issues with it. I have a 400W Dual amplifier and a small 8" MCM subwoofer. The head unit is a JVC Arsenal KD-AR555. The...
Top