Recent content by 14WRX

Thanks for the response. Is it inevitable that the carpet will get messy? I don't care since it will be covered just wondered?

I got a custom fit box and the new sub doesn't mount with the old holes. What should I use to fill the old mounting holes? The box is carpeted. I have read some used wood filler or silicone. What do you suggest? If you suggest the silicone what kind? What about just filling them with...

When tuning a mono block amp with an external bass control knob, do you turn the knob up all the way before touching the gain? I purchased an Alpine MRV-M500 matching it to a JL 10W3V3. I also didn't know if the bass knob acts as the boost control or a gain control? It makes sense to turn it...

Great thanks a lot for the responses! I just want to make sure I do it right. It will the be the rockford fosgate 4AWG power and ground kit.

Is this the correct ring terminal to use for the JL Audio JX500/1D? If not what would you guys suggest? Might be a stupid question but you don't just put the bare wire in the amps terminals do you? XD-RT4-4PAK - Car Audio - Connection Systems - Power Connections - Ring Terminals - JL Audio

Great thanks!   ---------- Post added at 03:41 PM ---------- Previous post was at 03:41 PM ----------   Is this amp overkill for this sub or do you guys think it's a good match?

I am only hooking up one 10W3V3-2 to the JX500/1D. The amp has 2 + (positive) inputs and 2 -(negative) inputs. Does it matter which positive and negative ones I choose? On a mono amp there is usually only one postive and one negative. It doesn't say in the manual. Is there a good guide on here...

I am only hooking up one 10W3V3-2 to the JX500/1D. The amp has 2 + (positive) inputs and 2 -(negative) inputs. Does it matter which positive and negative one I choose? On a mono amp there is usually only one postive and one negative. One other question is the bass boost on the amp. Does...