Recent content by 02envoy

I use a Diamond D9 12 inch sub in a 1.5 CF sealed enclosure in my Envoy. The bass is very tight and not boomy. I purchased new for $250. I am using with a Diamond D7401 800RMS amp. I highly recommend if this is something in your budget.

There are 3 sets of RCA jacks, one marked tweeter, one marked midrange, and the last set is not marked. Two questions Which RCA jack should my front component speakers hook up to Which RCA jack should my subwoofer hook up to Does it matter? Thanks for the help

Email Pat Szeman at Kinetik Audio. Pats@kinetikaudio.com. I just purchased an HC2000 from them. I ordered on Friday and it was received on Monday. They are located in Toledo Ohio. Just tell him you want his group buy price from this website. Excellent person to work with.

Using 1/0 gauge wire..... Battery negative to chassis Alternator to battery positive Chassis to engine

I haven't run them yet. I want to make sure I don't have to re-run cabling. Thanks for the remarks. It will be easier to run them together rather than separately.

Any issues with this concept? I have my amps in the rear of my SUV and all the wires will obviously go to the front. Is it worth trying re-route some of these differently? Thanks

Thanks for the replies. I noticed many of these distribution/T blocks vary in price from Stinger for a non fused application.

Is there a difference between these two? Stinger makes T blocks and distribution blocks. Can you just use a T block for power and ground cables or do you need to use a distribution block for power and a T for grounding only?

Check out http://www.kinetikaudio.com

I have the hex comps as well and I was wondering if someone may know what frequencies the RAF will play compared to the front? Are they the same?

Anyone give me some input as to whether or not power wire, fuse holders or distribution block quality matters? There are so many different price points for what appears to be the same wire, is it just a different color or is there something I am missing? Same thing for fuse blocks and...

I will be purchasing a 0/1 gauge wire kit for 2 amplifers, Diamond D7401 (800RMS at 2 Ohms) and Diamond D7152 (2 X 150 RMS) The wiring will be the following 4 gauge into a distribution block into a single 0/1 gauge wire. My intention is to use a 150 watt fuse near the battery with an inline...

Interesting information regarding the RCA jacks and power wires running next to each other. It will be much easier to run them along the same route.

I intend on using 1/0 gauge wire through a block and then broken down into two 4 gauge wires. The question I have, Does the distribution block need to remain as close as possible to the amps? Regarding the ground wire, Does this need to be 1/0 or 4 gauge wire? I intend to wire each amp...

What is the best way to wire two separate amps that will be located next to each other in my SUV. I assume a single power cable can be used to the battery? I assume I can use a distribution block? I have a 2X150 watt and a 1X800 watt amp. The 2 X 150 will be 4 ohm to the front speakers, and...