wtt for 2 ch amp

chrisw91
10+ year member

Senior VIP Member
Rating: 0%
0 0 0
i need a 2 ch that will do at least 50x2 @4. would like for it to be a good, reliable amp, and also small enough to fit underneath a bench seat in my truck.

so what i have for trade is my paintball gun:

it is a spyder vs1, its electronic with semi, or 3 round burst with eyes. i put a 14 inch j&j barrel on it. i have only used it about 10 times, and after each time i would strip the gun down, clean all internals, and lube up the o-rings. very well taken care of.

comes with the gun, both stock and j&j barrel, charger (2) 20 oz tanks, (1) 9 oz tank, standard jt mask, harness, 2 pods, and some misc. parts (internals, o-rings, lube) everything you see in pic

P1010131.jpg


P1010132.jpg


 
Sorry it took so long man, I went to the pens game last night. I dont have the birth sheet anymore but if you check rockford's site out they have an archive of all the actual power there old school stuff put out. It does 70x2 at 4ohms

125x2@2ohms or 250x1 bridged but as we all know these were a good bit underrated, I would be willing to bet it is a little over 300 bridged rms

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

chrisw91

10+ year member
Senior VIP Member
Thread starter
chrisw91
Joined
Location
phoenix, az
Start date
Participants
Who Replied
Replies
20
Views
913
Last reply date
Last reply from
chrisw91
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top