WTB amp for sub 450-650 @ 4ohms

Status
Not open for further replies.

JoshC
10+ year member

The Taco MASTA
Rating: 100%
3 0 0
As title states need an amp for my JBL p1022. 500-700rms @ 4 would be perfect.

When first powered up, my memphis wont receive signal until u pop top of its case. Steve at Ampmedics has recently worked on it, has no idea what the problem is. Will do parcial trade if u think u can fix/use it. Model's in sig

Other wise looking to spend about 150shipped

 
look on ebay for an alpine mrp m1000 think they do 600 at 4 ohms, but there usually under rated by 100-200 watts so prob around 700 rms at 4 ohms and i think you can get them f0r 150 shipped on fleebay.

 

---------- Post added at 01:12 PM ---------- Previous post was at 01:12 PM ----------

 

used of coarse.

 
I have the Zed Audio made USA US Acoustics 2150 SeriesII up for grabbs,and it is very clean and will do nicely at the 4ohm mono load within the classifieds?? $130.00 shipped.I had it pushing a 1000rms dvc 2ohm 10,and had it at close to 1'clock and pounded nicely!!!!I have the original specs pamphlet that I can make you a copy of the info as well..Specs as followed:

@4ohms-150x2

@2ohms-250x2

@4ohms Mono/Bridged-500x1

All ratings are @12.9v

THD-0.01%

Noise below rated output-107DB

Idle current0.9a

Fuse rating-35a

Size-L=15.7in/W=6.3in/H=1.9

Weight=8.0lbs

I currently have two of these amps,I had a total of 4 at one time..1 on each sub,and sounded quite Rich

Pm me and let me know???Thanks

 
Status
Not open for further replies.
Activity
No one is currently typing a reply...

About this thread

JoshC

10+ year member
The Taco MASTA
Thread starter
JoshC
Joined
Location
Houston, tx
Start date
Participants
Who Replied
Replies
9
Views
1,083
Last reply date
Last reply from
audiobaun
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top