Wtb 0 Gauge Terminals

[22mountaineer 10+ year member]

I need a couple of 0 Gauge terminals to run my wire to my rear battery, I was going to just get one of the top post battery hookups from Auto Zone but I assume it will cause a little bit of resistance..

Also I have an NSB 90 and an alluminum buss car that is about 1/8 thick with just alot of holes in it and I need some clamps that I can connect to my wire and screw them to the buss bar with a bolt and nut. Excuse my stupidity and forgetting the name of it, brain fart. It is some what like them 4 gauge battery clamps..

Click to read more...

 

[jrobb 10+ year member]

just use ring terminals to connect to the buss bar

 

[ViolentAudio]

how many do you need?

 

[loudcartunez 10+ year member]

i have plenty 2/0awg connectors will fit 0 gauge fine they are 1.00 a piece unless u buy more than ten than discount after that

 

[22mountaineer 10+ year member]

how many do you need?

I will need 2 for the power, 2 grounds, I also need some batt terminals that have 2 0 gauge outputs

When you only have a 4 gauge input on an amp what would be the best way to run a hot?

Reason I am asking, is because say my amp needs 200Amps, and a 4 gauge wire can only handle 150, then I will be short 50... I just dont see why I will have 2 hot runs (0Gauge) and an extra batt in the back when I will only use a 4 gauge run from batt to amp.

Then it depends on what kind of wire I run to amp.