Will this work?

[Zero_Signal 10+ year member]

I'm thinking of getting the kicker KX600.1 amp and two kicker 10" subs.

The amp runs at 600w X 1 @ 2 ohms and the subs have an rms of 300w and are 4 ohms each.

Would this work?

Also if this does how should I wire the subs?

Click to read more...

 

[blaza20s 10+ year member]

yes it would work just wire all pos together n all neg together

 

[lostsoul 10+ year member]

Depends on the coil config of the subs. If there single voice coil 4 ohms then you could wire the in paralell to a 2ohm load

 

[SSS 18734 5,000+ posts]

That would work very nicely. Just wire both subs in parallel... assuming they are SVC that is

 

[Zero_Signal 10+ year member]

No, they are dual 4 ohm voice coil, so would this amp not work. If not what similar amp would work.

Thanks

 

[PhatTonyDeMarco 5,000+ posts]

I have a JBL BP600.1, does 600w x 1 at 2 OR 1 ohm, very good amplifier. $130 shipped... People keep backing out on me here. //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif