What is the Bass Knob actually controlling

GKella

Junior Member
I recently bought a hifonics amplifier that came with a HFR-3 bass knob. It says boost on it from min to max, so i am assuming that it controls the bass boost is this correct? Or is it a remote gain knob that is very misleading? Should i even use it?

 
most of the time the "bass knob" afaik is just an attenuator, so all it does is vary the input signal. So it shouldn't act the same as the bass boost setting on your amplifier - which btw most people on here will tell you to keep turned off if you want your gear to last.

 
It really depends on the amp, on a fosgate depending on if it's set to hp or lp it boost tones at either 40hz and 15khz these are close probably not exact I'm going off memory and it isn't what it used to be! On a low end Ma audio it's a remote gain control. so it varies just got to read up.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

GKella

Junior Member
Thread starter
GKella
Joined
Location
Colorado
Start date
Participants
Who Replied
Replies
3
Views
3,182
Last reply date
Last reply from
goingdef
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top