*Weld*

[MustangGT25YRS 10+ year member]

*NM*

Click to read more...

 

[bumblebeerx8 10+ year member]

i do im certified what you looking to get done maybe i can help out

 

[97cavy 10+ year member]

Where in NY are ya? I knew a few guys around the albany area that could probably get the job done

 

[MustangGT25YRS 10+ year member]

*NM*

 

[MustangGT25YRS 10+ year member]

Where in NY are ya? I knew a few guys around the albany area that could probably get the job done

**************^^^^^^^^^^^^^^^^^^^^^^^****************

*NM*

 

[bass-aholic 10+ year member]

Hello Guys/Well,I'm looking to have a *Battery Tray* made up for my 1989/Stang GT.

It would be for the *Factory* location.I had one made up a few years ago from 1/4" Thick Plate Steel,that I still have.This can be used for the "TemPlate" for the Stainless one,which *I'd also like in 1/4" thick*...

It has sides all round it,and had two holes drilled on the one side[inner Fender Well] to allow for the 2/factory bolt mounting location.The sides were welded on the plate that the Batt. sits on from underneath.

The side of my tray,by the Strut Tower has a *Radius Bend* for fitament purpose. So an approx. estimate on this SS Battery Tray.Thank You for your Time/Help and Response.PM is good.Appreciated.

Regards/

Raymond

Where in ny are ya? Im on long island and would do it for the cost of materials and shipping alone, or just shipping if your fine with me using some angle iron i have laying around.

 

[MustangGT25YRS 10+ year member]

Where in ny are ya? Im on long island and would do it for the cost of materials and shipping alone, or just shipping if your fine with me using some angle iron i have laying around.

****************^^^^^^^^^^^^^^^^^^******************

*NM*

 

[MustangGT25YRS 10+ year member]

*NM*

 

[MustangGT25YRS 10+ year member]

**NM**

 

[MustangGT25YRS 10+ year member]

thnx anywey