Ups Ftw???

Well I got her installed tonight. Man that 0/1 is a pain to work with. I didn't really get a chance to set the gains and get everything setup properly, it was just kinda a quick get it installed type of deal. I'll be getting pics up tomorrow hopfully of the finished product. Right now wire is everywere and everything is torn apart.

Right now I can't notice a difference in loudness. I know I don't have the gains and what not fully adjusted but I thought I'd see a difference. I'm also not getting as much excursion as I used to. I had the gains slightly over 1/2 and couldn't get any good excursion out of the W7? Wierd, I'm hoping i just need to fine tune it. I had my truck running and didn't notice any dimming so I don't think voltage is an issue. Also the bass boast is at 0. Like I said earlyer, I really hope I'll get it all worked out tomorrow. I'd be pretty pissed if my $400+ amp didn't get any louder then the Kenwood POS I had in before!

If you have any ideas please share. I'll fine tune everything tomrrow and get back to you all with the results

Jon

 
I expect 600W+, and considering my Kenwood puts out 300 TOPS on its best day. I kinda expect a noticable change...


Jon
adding power's not the greatest way to gain SPL. It works a bit, but it's rarely ideal and usually expensive for what you gain, even with power as cheap as it is.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

kickerlivinloud

10+ year member
Banning survivor
Thread starter
kickerlivinloud
Joined
Location
Finger Lakes, NY
Start date
Participants
Who Replied
Replies
22
Views
1,258
Last reply date
Last reply from
OneKrazyKeebler
IMG_20260506_140749.jpg

74eldiablo

    May 22, 2026
  • 0
  • 0
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top