Strapping ED Nine.1's, DD 9512g

[raz0rxx 10+ year member]

I ordered two nine1's back in September and they just arrived, went to hook them up and got a bit confused about how to strap them. Going to strap them to a single D2 DD9512g. I have the electrical to back it up. Question is, does anyone have a diagram with the wiring and amp settings that need to be changed? Will I need to mess with phase at all? I have one amp set on master and one set on slave, all filters set, gain at half, no BB, strap cord connected. Any information on how to do this would be much appreciated!!

-Steve- //content.invisioncic.com/y282845/emoticons/verymad.gif.3f39c5c2fd57527b671fad3efdfac756.gif

Click to read more...

 

[raz0rxx 10+ year member]

Bumpssss....

 

[pieper88 10+ year member]

usually you have to connect two of the speaker outputs together. But, I'm not sure which ones on the nine.1's since they've got the 4 outputs. Contact ED and they will be glad to help you out.

 

[Beatnoutdaframe 10+ year member]

if it is like dd amps wire the sub down to 1 ohm then take the positive to amps positive post then the negative to the other amps positive then run a jumper wire between the negatives on the amps

 

[pieper88 10+ year member]

if it is like dd amps wire the sub down to 1 ohm then take the positive to amps positive post then the negative to the other amps positive then run a jumper wire between the negatives on the amps

yeah, expect Nine.1s aren't techinally stable at 1 ohms strapped.