murph 10+ year member
Low for Life
Item(s) for Sale:
An old school RF 501s
Item(s) Description/Condition:
The amp is in good working condition and cosmetically is a 8/10.
Details:
125 watts RMS x 2 at 4 ohms
250 watts RMS x 2 at 2 ohms
500 watts RMS x 1 at 4 ohms in bridged mode
stereo or bridged mono output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way crossover required)
requires 8-gauge power and ground leads and a 50-amp fuse -- wiring and hardware not included with amplifier
continuously variable 50-250 Hz high-pass/low-pass (12 dB/octave) crossovers
MOSFET power supply and output devices
MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability
TOPAZ -- noise-killing differential inputs that eliminate 80% of ground loop noise
Trans•ana circuitry keeps preamp voltages low and signal paths simple for outstanding audio quality
NOMAD -- advanced protection circuitry for "intelligent" shutdown protection
wired remote included for fingertip control of Punch Bass (0-18 dB boost at 45 Hz)
12-1/16"W x 2-3/8"H x 9-7/8"D
Price:
110 plus shipping
Shipping and Miscellaneous Item Information:
buyer pays shipping
Item Pictures:
View attachment 26531014View attachment 26531015View attachment 26531016View attachment 26531017
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).
An old school RF 501s
Item(s) Description/Condition:
The amp is in good working condition and cosmetically is a 8/10.
Details:
125 watts RMS x 2 at 4 ohms
250 watts RMS x 2 at 2 ohms
500 watts RMS x 1 at 4 ohms in bridged mode
stereo or bridged mono output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way crossover required)
requires 8-gauge power and ground leads and a 50-amp fuse -- wiring and hardware not included with amplifier
continuously variable 50-250 Hz high-pass/low-pass (12 dB/octave) crossovers
MOSFET power supply and output devices
MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability
TOPAZ -- noise-killing differential inputs that eliminate 80% of ground loop noise
Trans•ana circuitry keeps preamp voltages low and signal paths simple for outstanding audio quality
NOMAD -- advanced protection circuitry for "intelligent" shutdown protection
wired remote included for fingertip control of Punch Bass (0-18 dB boost at 45 Hz)
12-1/16"W x 2-3/8"H x 9-7/8"D
Price:
110 plus shipping
Shipping and Miscellaneous Item Information:
buyer pays shipping
Item Pictures:
View attachment 26531014View attachment 26531015View attachment 26531016View attachment 26531017
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).
Last edited by a moderator:
