soulnomad 10+ year member
i has free bikes.
Hey guys, okay first off my recone is back off completely, no residues of anything left behind and it will definitely be able to be reinsinstalled. My question though is one strand of my voice coil started to unwind. It unwound about an inch back, no bends, just broke and lifted from coil rub. I was thinking I could sand it down to bare copper and and use a little bit of solder to reattach ( i get continuity when i push the awry strand back to where it broke), and gently sand the solder down flush. I know I need some type of epoxy to spread over the coil, david recommended that I use the same devcon that I used for the recone, but i was just wondering would the solder hold up to the heat and could i still push the coil to 100% again? also what type of epoxy would hold up to the heat? thanks guys, I really appreciate any help!