Jeremy11
Junior Member
So this is probably a dumb question. I am running 2 amps bridged, 1 for tweeters and 1 for mids off of a pioneer hu in network mode. Will i need rca splitters (not sure of proper name) one female end 2 male ends?
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
No make or model number on it? Do you have an exact picture of the rear and all its glory?
- Started by Alex prior
- Wiring, Electrical & Installation
Use two sets of RCAs. One set for the Front channels and the other for Sub Output and into Rear Input on the amp. Turn off the Rear Filter on the...
- Started by Aryan
- Amplifiers
Thanks a ton for your suggestion to my rather long query, I ll follow it and see how it works out.
Thanks again
- Started by Aryan
- General Car Audio
He'll be fine with any 4 ohm speakers, tuned properly.
The focals are rated for 100 watts nominal and with the passive crossovers and power to...
- Started by haught
- General Car Audio
Try this other test; get a 3.5mm headphone repair cable and connect it to the LC7i input. Connect that to your phone and measure. This will tell...
- Started by ChillyWilly72
- Wiring, Electrical & Installation
About this thread
New threads
-
-
-
-
2 more questions about the Kenwood DDX9907XR / DMX907S
- Started by fadetoblack73
- Replies: 0
-
