Quick question

[Beerdrnkr 5,000+ posts]

I have a power distro w/ voltage display and have no idea if I'm supposed to add a remote wire or a ground somewhere on it to get the display to light up. I have the Scoshe PDMWF4D and can't find any installation info on it. Thanks

Click to read more...

 

[steveBeatz]

Ya you need a remote man, I had same issue with a soundstream one I had, Just run a remote off one of your amps to it. But mine had a spot for the remote so if yours doesnt im not sure.

 

[DonH 5,000+ posts]

should have a spot where you can run a remote wire to like steve said

 

[Beerdrnkr 5,000+ posts]

I see no spot for it? Where one of the screws go there seems to be like a piece of foil or something. I don't see any obvious spots for a remote wire though.

 

[SPL Blazer 10+ year member]

I checked their website and they have nothing listed for installations. There should be a spot with a set screw on the block that the display is mounted to, on the side or the bottom.

 

[infamous_e46 5,000+ posts]

Just take a red marker and write 14.4v on the display //content.invisioncic.com/y282845/emoticons/naughty.gif.94359f346c0f1259df8038d60b41863e.gif

 

[Beerdrnkr 5,000+ posts]

Just take a red marker and write 14.4v on the display //content.invisioncic.com/y282845/emoticons/naughty.gif.94359f346c0f1259df8038d60b41863e.gif

Then now I have a 16v system...woohoo //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

I don't know what I should do **** it.

 

[steveBeatz]

Finish your system!! //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[SPL Blazer 10+ year member]

Just wire it up without the voltage meter, or buy a better one.