Question about hooking up speakers to amp

cerebus1
10+ year member

Junior Member
13
0
VA
I've got a pair of POLK DB690 6x9s (4 ohm) and a Polk DB 10" sub SVC that I want to hook up.

I am planning to run this with a PG Octane R5.04. RMS on the amp is:

4 OHM Stereo - 50x4

2 OHM Stereo - 75x4

4 OHM bridged - 150 x2

To get the most power, I would assume that the 4 OHM bridged is the way to go...I planned on bridging the sub on the 2 rear channels.

1) Can I bridge the 6x9s ??? If so, I assume that this is the best way??

Also, the amp has built in crossovers...If I select low pass for the sub, it sets the front to High pass.....

2) Will I lose alot of the bass on the 6x9 if I have it set to high passs....

3) Also what setting for the filters would you suggest?

4) Do you think 150w will be enough for the sub (it is supposed to handle

250+ rms)

Thanks

Doug

 
run the 6x9s off the front two channels, high passed at about 100 or so

run the sub bridged off the rear two channels, low passed at about 80 or so

you can adjust those crossover points, im just giving you a starting place... and no thats probably not enough for the sub, but you can do it until you upgrade

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

cerebus1

10+ year member
Junior Member
Thread starter
cerebus1
Joined
Location
VA
Start date
Participants
Who Replied
Replies
3
Views
392
Last reply date
Last reply from
cerebus1
561786595_18427607485102160_7010259965928918509_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0
561583216_18427455586102160_8141545757991593433_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0

New threads

Top