Precision power amp, four 4 ohm speakers

[Loner84]

Hello all. I've been working in my classic

Chevy for some time now and ready to install

The sound system. I know nothing about car audio

So I could use some help. If I could post my equipment

With specs, I'm hoping a guy could take that data

And come up with a giagram to go off of. I can do diagrams

But calculating ohms respective to my amps specs is way over

My head.

(1) 4 or 2 channle provision power A404 amp

(1) 2 channle kicker amp

(4) clarion 4 ohm 4" speakers 140 watt peake 30watts continues

(2) 4 by6 " kicker speakers ( door panel ) 400 watts

(1) 12" kicker sub

The deck is kenwood KFC-mp145 with only one

Set of RCA

Click to read more...

 

[trumpet 5,000+ posts]

You should sell that head unit and get one with 3 sets of RCA pre-outs. The easiest way to run all this equipment is to wire the Clarion speakers in pairs so you will have 2 ohms x 2 on the front channels of the A404, then wire the Kicker speakers to the rear channels of the A404. Check to make sure the Kicker amp is compatible with the ohms of the sub.

This would also be a good time to look around for a reputable car audio shop to do the install.

 

[Loner84]

Another question , when you say pare the clarions , do you mean parallel or series two of them

Together?

 

[Loner84]

Another question , when you say pare the clarions , do you mean parallel or series two of them

Together?