JiggaD369 10+ year member Bedroom Gangster 738 0 NJ Dec 18, 2006 #1 I'm thinking about switching from a PPI 15" Flat Piston to a JBL W12GTi. I understand that A600 will only do 4 ohms and the JBL is a Dual 6 ohms speaker. Will the A600 handle 3 ohm load? Click to read more...
I'm thinking about switching from a PPI 15" Flat Piston to a JBL W12GTi. I understand that A600 will only do 4 ohms and the JBL is a Dual 6 ohms speaker. Will the A600 handle 3 ohm load? Click to read more...
helotaxi 5,000+ posts Kilroy was Here 8,961 73 South Central (New Mexico that is...) Dec 18, 2006 #2 The W6 series from JL (originals not the V2) were the same config and there were plenty of people that ran that amp to one of them.
The W6 series from JL (originals not the V2) were the same config and there were plenty of people that ran that amp to one of them.
OP JiggaD369 10+ year member Bedroom Gangster 738 0 NJ Dec 18, 2006 Thread Starter #3 Should I just use a Sedona 500ix instead?
Paul73 10+ year member Senior VIP Member 367 0 Hampton, VA Dec 18, 2006 #4 After box rise you should be fine with the Art.
OP JiggaD369 10+ year member Bedroom Gangster 738 0 NJ Dec 18, 2006 Thread Starter #5 Does the A600 max out at 600w since it's regulated? or does it produce more power? I also have the Sedona at disposal for more power.
Does the A600 max out at 600w since it's regulated? or does it produce more power? I also have the Sedona at disposal for more power.
