Power wire in 99 Bonneville SSEi

  • 3
    Participant count
  • Participant list

radel2dope
10+ year member

Senior VIP Member
I have been having trouble trying to figure out where to run my 2 ga. power wire from my battery to my trunk. There seems to be no holesin the fire wall to run it because the car was never offered as a manual. Any other places people have had success? Thanks

 
In late 90's Bonnevilles I usually drill a hole, very high on the passenger side firewall between two large plugs. You have to drill from the engine side into the interior; you'd definitely want to use a step drill bit and take it slow, so you don't drill into any components.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you will be just fine to be honest. Id run it and check it after hammering on it quite a bit and check the temp on the wire by hand to see...
2
1K
So u know the individual slots on the ISO connectors and where they go? 12 volt red is accessories. etc. Red wire goes to the amplifier...
8
1K
Oh, total opposite. i play with storage bins full of wire scraps from past installs for fun. I hoard decent grade wires from audio homies...
6
1K
If you have multiple amps you do not need to run a power wire from each amp to battery.. You can have a single run of wire with a distribution...
1
1K

About this thread

radel2dope

10+ year member
Senior VIP Member
Thread starter
radel2dope
Joined
Location
Mankato, MN
Start date
Participants
Who Replied
Replies
3
Views
616
Last reply date
Last reply from
radel2dope
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0
Screenshot_20240523-151806.png

1aespinoza

    May 23, 2024
  • 0
  • 0

New threads

Top