Plexi glass sterring wheel

[fbi90909 5,000+ posts]

its all in the mold that you make i think. if the mold is good the ending effect /product should be good. its preety simple but hard at the same time

ahhh, i though you were going to be wraping a steering wheel with plexi.. if it's an fill in then it shouldn't be too hard. over on fiberglassforums.com there is a thread about how to make molds. pretty sure you can make a fiberglass mold and use that as your steering wheel mold. as for you wanting a sparco one, i would rather suggest the likes of a normal car steering wheel where it has the ribbed back end for some sort of grip. just to be safe ya know?

 

[RipDaJacka]

Buy a aftermarker (cheap Grant or something) and build off that base. and Please god, dont make it Ghey shaped like fishman's