I'm done with car audio and need to get this stuff sold and out of the house. Prices do not include shipping. Shipping will be based on your location. Buyer will be paying for shipping, I will not. Pay Pal is the preferred payment method.
First up are the Phoenix Gold RSd65cs 6.5" components. I used them for a summer then got a new car, so I took them out. I planned to install them on the new car, but never got around to it. As many of you know they are great components for the price.
Specs-
* RSd 6-1/2" 2-way Component Speakers System
* Power Handling:
* Peak: 240 watts per set / 120 watts each side
* RMS: 120 watts per set / 60 watts each side
* Injection Molded, Aluminum Plated Polypropylene Cone woofer
* Butyl Rubber Surround
* Rigid Powder Coated Steel Frame
* Interwoven Tinsel Leads
* Optimized Magnet/Motor Structure
* Sensitivity: 88 dB
* Frequency Response: 45 Hz - 20 kHz
* 4 Ohm Impedance
* Mounting Depth: 2-7/8"
Price is $55 plus shipping and Pay Pal fees.
Next up is the Profile AP600 2 channel amp. I used this amp to power the PG components and it did a fine job. Always was reliable and never gave me any problems.
Specs-
* 2-channel car amplifier
* 100 watts RMS x 2 at 4 ohms (150 watts RMS x 2 at 2 ohms)
* 300 watts RMS x 1 bridged output at 4 ohms (4-ohm stable in bridged mode)
* variable filters (low-pass from 50-250 Hz, high-pass from 80-1200 Hz, at 12 dB per octave)
* variable bass boost (0-12 dB at 45 Hz)
* stereo or bridged mono output
* Tri-way capable (Tri-Way crossover required)
* preamp- and speaker-level inputs
* preamp outputs
* fuse rating: 20A x 2
* 10-11/16"W x 2"H x 10-5/16"D
Price is $70 plus shipping and Pay Pal fees.
Any questions, just ask.
As far as references/feedback goes I have over 100 100% positives eBay and PBnation feedback. I can provide that feedback through a PM if you are uneasy about that.
First up are the Phoenix Gold RSd65cs 6.5" components. I used them for a summer then got a new car, so I took them out. I planned to install them on the new car, but never got around to it. As many of you know they are great components for the price.
Specs-
* RSd 6-1/2" 2-way Component Speakers System
* Power Handling:
* Peak: 240 watts per set / 120 watts each side
* RMS: 120 watts per set / 60 watts each side
* Injection Molded, Aluminum Plated Polypropylene Cone woofer
* Butyl Rubber Surround
* Rigid Powder Coated Steel Frame
* Interwoven Tinsel Leads
* Optimized Magnet/Motor Structure
* Sensitivity: 88 dB
* Frequency Response: 45 Hz - 20 kHz
* 4 Ohm Impedance
* Mounting Depth: 2-7/8"
Price is $55 plus shipping and Pay Pal fees.
Next up is the Profile AP600 2 channel amp. I used this amp to power the PG components and it did a fine job. Always was reliable and never gave me any problems.
Specs-
* 2-channel car amplifier
* 100 watts RMS x 2 at 4 ohms (150 watts RMS x 2 at 2 ohms)
* 300 watts RMS x 1 bridged output at 4 ohms (4-ohm stable in bridged mode)
* variable filters (low-pass from 50-250 Hz, high-pass from 80-1200 Hz, at 12 dB per octave)
* variable bass boost (0-12 dB at 45 Hz)
* stereo or bridged mono output
* Tri-way capable (Tri-Way crossover required)
* preamp- and speaker-level inputs
* preamp outputs
* fuse rating: 20A x 2
* 10-11/16"W x 2"H x 10-5/16"D
Price is $70 plus shipping and Pay Pal fees.
Any questions, just ask.
As far as references/feedback goes I have over 100 100% positives eBay and PBnation feedback. I can provide that feedback through a PM if you are uneasy about that.
