PAC SOEM-T - Quick question please

[joem1cha3l 10+ year member]

I am going to connect this to my subwoofer so that I can run an amp. I plan on tapping into the subwoofer wires (post/neg). However there are two sets of pos/neg for the speaker side. Do i just connect the right speaker pos/neg and cap of the left side or do i connect both pos/negs?

Click to read more...

 

[Kangaroux 5,000+ posts]

by two sets of wires do you mean dual voice coils?

 

[gunz4me2 10+ year member]

I used one set from the factory amp going to the sub in my wife's Genesis Coupe to wire to the PAC SOEM-T.

If you are just using ONE set of factory wires going to the PAC SOEM-T, connect the Gray and White wires together on the SOEM-T and connect this to the positive wire on your factory speaker. Connect the White/Black stripe and Gray/Black stripe wires together on the PAC SOEM-T and connect this to the negative wire going to your factory speaker. I just put heat shrink around the black wire on the speaker input side of the SOEM-T

 

[joem1cha3l 10+ year member]

gunz, thanks i think thats what i needed. if i am connecting it to a DVC sub, would i connect each side to the wires coming from each coil?

 

[gunz4me2 10+ year member]

Hopefully this explains it better:

I took it from the SOEM-T manual and colored it (hope they don't mind, lol). Red would be the wire going to your factory speaker's positive lead, black would be factory speaker negative.