SOLD Os Mtx Cheap

stopdrpnro
10+ year member

Senior VIP Member
these old school beast have individual l/r gains, will take 8v pre-outs and most importantly will easily put out their "dynamic" power ratings. only trades i'm looking for are a small battery i.e. stiger sp800 or spv44

mtx Thunder250 - in great shape , nice small foot print.

RMS Power measured at 12.5 Volts DC:

25 Watts x 2 into a 4 Ohm load with less than 0.05% THD+N

50 Watts x 2 into a 2 Ohm load with less than 0.1% THD+N

100 Watts bridged into a 4 Ohm load with less than 0.1% THD+N

Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC

55 Watts x 2 into a 4 Ohm load

100 Watts x 2 into a 2 Ohm load

200 Watts bridged into a 4 Ohm load

$50shipped-pending

mtx thunder 2150x -both in great shape.

RMS Power measured at 12.5 Volts DC:

75 Watts x 2 into a 4 Ohm load with less than 0.05% THD+N

150 Watts x 2 into a 2 Ohm load with less than 0.1% THD+N

300 Watts bridged into a 4 Ohm load with less than 0.1% THD+N

Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC

120 Watts x 2 into a 4 Ohm load

212 Watts x 2 into a 2 Ohm load

425 Watts bridged into a 4 Ohm load

$75 shipped -each only one left

DSC_0022.jpg


 
yea my bad lol.. what i was trying to get to was would u give any sort of discount for buying both? and im in raleigh so i could prob come get them..

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Thanks buddy! Given me a lot to think about in terms of what to do; I've been watching YouTube videos on this stuff all day as well so I really...
4
856
You can wire those subs up @8 ohms if they are both SVC4 ohm subs,and that amp will run fine after being tuned properly...
4
1K
The 240 should be 2x40/ 2ch. rated at 11.9v. Should generate close to 50+ @14v rms. Only Rated @4 ohms bridged Mono.. Should be around 125 rms...
5
2K
In 1990: The MTX MTA 225 had a MSRP of 549.95 25x2 0.02% THD S/N 102 12x 8 1/2x 2 3/8 The MTX MTA 250 had a MSRP of 649.95 50x2 0.02% THD S/N...
5
2K
My first install on my vehicle was in '94 right before I turned 18 😂 I'd "helped" on a few starting at 16 but my helping was mainly gofer work...
19
3K

About this thread

stopdrpnro

10+ year member
Senior VIP Member
Thread starter
stopdrpnro
Joined
Location
durham ,nc
Start date
Participants
Who Replied
Replies
22
Views
1,125
Last reply date
Last reply from
jdawg
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top