Orion 2400D

[geowick07 10+ year member]

I am looking at a Orion 2400D mono amp. From the pictures i have seen, it looks like there are two sets of + and - posts on this amp. how would i wire this to run ohm stable to two 4ohm DVC subs. Just bridge the posts together?

thanks for any input!

Click to read more...

 

[johnecon2001 5,000+ posts]

The amp is already internally bridged. Just run one VC to one set of terminals and the other VC to the other set.

 

[geowick07 10+ year member]

Thanks for the info. i didnt even look to see if that amp is internally bridged. Thanks Again!

 

[smd4life 5,000+ posts]

they don't usually say that, but it's a monoblock(1 channel) so it's not really bridged, it's just easier to hook up multible speakers that may, and for some companies it's cheaper to use the terminals they already have

 

[geowick07 10+ year member]

so if that amp doesnt have 1/0 inputs, how do i power it? distro block? then run 4 gauge to the amp?

 

[smd4life 5,000+ posts]

you could do it like that, or make 2 runs of 4

 

[geowick07 10+ year member]

well in the future i will be running another amp, so would the distro block be a good idea? that way, wont need another install kit. just som wire from the block to the new amp.