ordered my xFire

[GrandAmGT 10+ year member]

Just ordered a Crossfire VR 2000D for my 2 L7's..

ok, ill be running the amp at 2 ohms...

how should my subs be wired for best performance?

Series? Parallel?

Click to read more...

 

[gellis4 10+ year member]

I think you need a 1 ohm stable amp if your going to run series.. you better send back that crossfire.. It's rated @ 2 ohms, i don't know if it is 1 ohm stable.

I'm assuming tha tyour subs are dual 4 ohms. I know that was the problem w/ your old MTX, it ran at the wrong ohms, and you're just going to have that same problem again.

Get an amp that will run max power @ 1, or 4 ohms, because those are the two lowest impedences you can run w/ a single amp.

if your subs are dual 2 ohm.. Good choice. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif . But i don't know if they made the L7 in dual 2...

 

[GrandAmGT 10+ year member]

Yeah, there Dual 2...so the amp is Totally Fine

 

[nswartley 5,000+ posts]

Originally posted by GrandAmGT Yeah, there Dual 2...so the amp is Totally Fine

wire them in series/parallel. itll give ya a 2 ohm load.

-nate

edit~thanks mike //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[MikeofTulsa Moderator]

actually series/parallel on 2 or more dual 2ohm subs will be a 2ohm load