NVX 900.5 Led slow blink, not turning on

[dacheatham 10+ year member]

I have had this amp installed for around a month with no issues. Wednesday it shut off while I was driving. I was listening to ESPN radio so not pushing it at all. It ended up coming back on a little later...I had done nothing in this time.

The amp played fine the rest of Wednesday and most of Thursday before shutting off. At no time did the amp show protect, nor show power.

I finally had some time today to look at it. I have 14+ on power and around 13 on remote. Ground shows good as well(at least while amp is off). I disconnected all of the speakers in case one was bad. Fuses are good also.

When I connect the RCAs the protect light will blink lightly, once. The NVX LED on top will also slowly blink.

Car is a 2011 sonata, stock radio into a Navone LOC. I have tested it and there is voltage coming out for the remote as well as RCAs.

I have taken the amp apart and do not see any bad spots.

Any advice?

Click to read more...

 

[wew lad 5,000+ posts]

what does the manual say that means?

 

[dacheatham 10+ year member]

That was the first place I looked. There is no mention of it, only troubleshooting speaks to power and protection lights.

 

[BoomTaco64]

ground location?

 

[wew lad 5,000+ posts]

That was the first place I looked. There is no mention of it, only troubleshooting speaks to power and protection lights.

interesting... not sure then lol watch the voltage as you turn the amp on, on both the remote and the power wire referencing the amps set screw so you know the amp is seeing what you're seeing