new precision power amps

[stevew007 10+ year member]

I'm not going to go over testing procedure with you... at least not right now. Far too lazy for that, and I'm sure you could find tons of info about it if you were to search. I will mention that I did not write that post as some sort of attempt to slam you or anything like that. I just regard a reasonably well-known magazine higher than most forum people, and I would expect all of you to do the same over me.

I'm not scared to be told I'm doing something wrong!that is what learning is for.I'm just stating how i tested the amp.I know how to clamp an amplifier.the mistake i did make was its not a 540.4 its the 320.4 and here is a couple of shot's I'm no amp expert by far maybe i need to match the gain and see what happens.I just bought the blazer and never planned on keeping that amp in there so there was no reason to mess with it.

 

[dragonrage 10+ year member]

Check out Basic Car Audio Electronics - lots of info there, but wade through it, figure out what interests you, and you can learn a lot.

 

[macsdad 10+ year member]

i was talking about the monoblock amps, thanks for all feedback.

 

[CFaist 10+ year member]

What's up. I've owned 2 Sedona S2000.1ds. Both were trouble free no nonsense no frills amplifiers. Would it do the rated 2000 rms I don't know never clamped for rms. but it would burp on a .5 ohm load (4 deka 9a31s ,2 runs of 1/0). Had it on my four American Bass TNT 12"s and did a 149.7 outlaw in my explorer. Great amp for the price. I would buy one again.