new Diamond components - amp wiring help

[Hartman 10+ year member]

So I just got a set of 6.5 Diamond D661s, this being my first set of components. 200w max. I also have an old Profile California amp laying around that I would like to use with these components. The specs on this amp are as follows:

100 watts RMS x 2 at 4 ohms

300 watts x 1 in bridged mode

150 watts x 2 at 2 ohms

I'm used to wiring subs, but with components I'm a little confused as to how I'm supposed to wire them. The mids are 4ohm svc obviously. How should I wire these to get max power out of them without damage?

The way I see it, if I just wire one channel to each crossover, each side will get 100w (theoretically), correct?

Click to read more...

 

[Hartman 10+ year member]

bump

 

[azbass 5,000+ posts]

um, you use the amp in 2 chan mode, one chan to one comp, and the other chan to the other comp.

 

[Hartman 10+ year member]

that's all I needed to know thank you.