My Fiberglass console thread.

lookin good.

make sure you sand it all nice. if you have problems getting the filler smooth - mix it with a little acetone and it will thin up. and when it starts to harden... get a small cup of acetone and put a glove on, dip your finger into the acetone and smooth out any lumpy sections.

the acetone will 'eat' away the filler and you can smooth it out - much like sanding, but WAY eaiser.

dont do TOO much. but it helps take out lots of small imperfections that would take twice as long to sand.

 
Da sanders are so nice... If it was mine I would run up to my buddys shop and finish it tonight, but I'm going to let him do it the good ol fashion way (block/hand sanding.) //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

mobileaudio219

10+ year member
Senior VIP Member
Thread starter
mobileaudio219
Joined
Location
Central, Missouri
Start date
Participants
Who Replied
Replies
7
Views
513
Last reply date
Last reply from
mobileaudio219
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top