My dilemma

[Hintzyboy 5,000+ posts]

OK here's my problem.

I'm trying to get as much output and SQ as I can in a small space (behind the seat of a single cab s10).

I have a 12" custom-built TC9 made by TeamPSI. I also have a 10" Eclipse SW8102 DVC. It is basically an Eclipse-branded TC7.

Here are my options:

1) Install the TC9 in about 2 cubes sealed or 1.5 cubes ported and sell the Eclipse

2) Pick up another TC7 and install it and the SW8102 in about 1 cube each and sell the TC9

3) Sell both and pick up something else (IDQs, PG RSDs, whatever)

No matter what setup I go with, it will be going on an Orion XTR Pro1000, putting out 1000W at 1 ohm (actually supposed to put out around 1200w, but it's rated for 1000 and I don't know of anywhere around here to get it benched.)

No matter what I get, I can only spend the money I get from selling my other equipment.

Thanks in advance,

Aaron

Click to read more...

 

[Atimm693 10+ year member]

Well,if you go with two subs sealed, it would be almost double the cone area.

I would do that and sell the TC9. However I think the other option may do just as well but will be slightly under 2 10s in output.

 

[Blove1991 10+ year member]

If you have a 2nd gen S10 then my setup is gunna consist of 3.20 cubes net with 2 10" Fi Ssd's ported to 35hz off a BXi2006D at 1 ohm

//content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

Just another idea to throw out there

 

[Hintzyboy 5,000+ posts]

If you have a 2nd gen S10 then my setup is gunna consist of 3.20 cubes net with 2 10" Fi Ssd's ported to 35hz off a BXi2006D at 1 ohm
//content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

Just another idea to threow out there

It's a 97 Reg. cab. I'm not quite sure how you're squeezing that much space out of the truck without loosing too much legroom. I also have to save some space for an amp rack.

 

[Hintzyboy 5,000+ posts]

and up