Monoblock Setup W. 12w6v2 Question

[SneaksFiend 10+ year member]

So I Gave Up My 2nd 12" Jl W6v2 And Just Decided To Run 1 W6v2. However My Amp Is A Hifonics Brutus Bxi1206d And Its A 1 Ch. Amp. But I Noticed When The Sub Got Hooke Up. It Was Wired At 2 Ohms. Question Is:

If My Amp Is A 1 Ch. Amp Doesnt That Mean I Can Only Set My Sub To 1 Ohm Or 4 Ohms?

If 2 Ohms Is Fine, Will My Amp Push The W6v2 To Its Highest Potential?

If It Can Be Wired At 2 Ohms And The Sub Will Be Pushed To Its Potential, I Need To Re Adjust The Setting On The Amp, Because I Turn My Volume Up To 32 On The Volume, My Bass Control Knob Is At Max Yet The Sub Still Sounds Low. Any Suggestions To Make The Sub Bump Better?

Click to read more...