lol clay ftw?

[XHiFiX 10+ year member]

Yeah I think I went a lil overboard. //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif Probably 'cause I had too much fun with it lol. //content.invisioncic.com/y282845/emoticons/crazy.gif.c13912c32de98515d3142759a824dae7.gif

Click to read more...

 

[azbass 5,000+ posts]

meh, I personally would not have used clay. and I really dont see why people like to use it.

 

[UndercoverPunk 5,000+ posts]

Because that's what is in the "Proper door deadening" thread. I don't think some quite grasp the reasoning for it.

 

[mlstrass 5,000+ posts]

rope caulk FTW.......clay is for kids LOL

 

[lilmaniac2 5,000+ posts]

as long as it doesnt fall off it looks pretty cool

 

[James Bang 5,000+ posts]

is that polyfill in the door?

 

[Beat_Dominator 5,000+ posts]

Looks like a clean job.

 

[lil azn 06 10+ year member]

Clean job but its a pain in the *** to take off cleanly. I dont think ill go back to clay =[

 

[XHiFiX 10+ year member]

is that polyfill in the door?

Well, it's actually made by Poly-Fil and it's a "densified batting" made of polyester fibers. Basically the same as poly-fil in easy to use sheets.

Found them for 6.99 at Joann's Fabrics when I bought the modeling clay. Looks like this.

And what I did first was spray-glue the Nu-Foam to some leftover sheets of eDead so they became like self-adhesive acoustic tiles. Then I cut them to the size I needed and stuck them inside the doors. Cheap and easy alternative to foam or deflex pads, imo.

 

[wesl56 10+ year member]

as long as it sounds good...

 

[OoMesKoO 10+ year member]

**** so i suppose my 6.5" components, with the 6.5" screwed into the door with 2 screws/no deadener is FTL.

I fail.

 

[James Bang 5,000+ posts]

I think it might be bad if water were to get into your doors w/ that fill in there. i could be wrong.

 

[Thieroff 10+ year member]

To be honest I had that "densified batting" in my doors at one time, it held a little bit of water but it didn't get moldy

CT

 

[jmanpc 5,000+ posts]

i wanna hear //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[CaliforniabOY5 10+ year member]

Report Back To Us Jordan