so i finally got around to almost finishing this today for my carputer (just needs to be sanded a little more then primed/painted)
and i noticed this after putting it in the car
that big ****in gap on the bottom. is the only way to fix this to build up the bottom and just kinda slowly sand it down till it fits? //content.invisioncic.com/y282845/emoticons/rage.gif.0ad8a6e5565b5fddce406566fdd05149.gif i may just end up leaving it like that, ****it.
edit -- would putting tape around opening, then filling the open spots while the dash is in the car, then removing it and taking off all the tape work?
and i noticed this after putting it in the car
that big ****in gap on the bottom. is the only way to fix this to build up the bottom and just kinda slowly sand it down till it fits? //content.invisioncic.com/y282845/emoticons/rage.gif.0ad8a6e5565b5fddce406566fdd05149.gif i may just end up leaving it like that, ****it.
edit -- would putting tape around opening, then filling the open spots while the dash is in the car, then removing it and taking off all the tape work?
