Sold Kicker Zr1000

dadon
10+ year member

CarAudio.com Elite
Rating: 0%
0 1 0
Guaging interest here, I have access to a Kicker Zr1000. This was one of the best amps of its time, its in mint condition. I can get pics for anyone really interested in the amp. It is my friends amp, and it has been babied. He bought it just to say he had a big amp, when in reality he was only pushing two alpine type s subs at 4 ohm not even bridged. The amp specs are below. He is asking 325 for it, thats a steal for that amp! This was the ultimate sq amp, and is known to do over 1500 watts if you have a good electrical system..I do have references: check my sig!

2 x 250W @ 4 ohms

2 x 500W @ 2 ohms

2 x 350W @ 1 ohm

1 x 1000W @ 4 ohms bridged

1 x 1000W @ 2.66 ohms bridged

1 x 700W @ 2 ohms bridged

THD: 0.02% (rated power, 4 ohms stereo, 12.5 to 16V)

Freq. Response: 10Hz ∼ 28kHz (+0,-1 dB)

S/N Ratio: >100dB (unweighted, at rated power)

Fuse: External 150A

Dimensions: 23.15" x 10" x 2.75" (58.8cm x 25.4cm x 7cm)

 
Mustang, just looking to get 350 for it, this amp costed thousands... thanks on the heatsinks polish, it does look good...
********************^^^^^^^^^^^^^^^^^^^^^*******************

Morning/

I've had people wanting to buy my ZR/1000's and some others I have.I have some plans for an all *Old School Kicker Amp System* in my Stang which will have a ZR/1000 per Eclipse 12" Ti Subs DVC-4/Ohm.They're old school too/:D.

Those ZR/1`000's ran for approx. $1200.00 each,depending on the Store.MSRP on them was $1499.00,IIRC.

I'm sure you've seen they are still wanted on E/Bay...But sometimes,the amps have broken mounting feet!!...WTH!.How in God's name you break the mounting feet??? Install them w/a Hammer?!/ //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif

I've seen the Polished heatsink ones in beautiful condition,amp badge and all w/2

Broken feet on them/:crap:...unreal.

Yours is in *NICE* shape,though/:veryhapp:.I'm sure someone will grab it,soon,that has the *Deep Pockets*,and it's not gonna hurt them.As said earlier,I wish I had the $$ to buy it,cause,it would be gone already/;).

I'd put a nice pair of polished end caps on that bad boy...WOOOTTT!!!!.Well,*All the Best w/Your Sale*.Take Care.

Regards/

Raymond

But,as you know...$$$'s is very tight,and people laid off/etc.

 
mustang... Where can I grab some Eclipse Ti or Ti Pros.. I wanted those soooo bad, but could not get the money for them. Maybe someone would trade for those.. 10s or 12's. Those things used to knock so hard and sound god! Tc sounds build correct? Didn't lightning audio have a speaker just like it? Anyway ttt, someone snatch this amp up.

 
mustang... Where can I grab some Eclipse Ti or Ti Pros.. I wanted those soooo bad, but could not get the money for them. Maybe someone would trade for those.. 10s or 12's. Those things used to knock so hard and sound god! Tc sounds build correct? Didn't lightning audio have a speaker just like it? Anyway ttt, someone snatch this amp up.
*****************^^^^^^^^^^^^^^^^^^^^*******************

Morning/

Have you tried *E/Bay*? Well...that's a stupid question/:rolleyes:.I'm sure you have.To be honest on the build,I'm not sure /:( .IIRC,there was mention of TC building the Ti's...

I have an Issue w/mine though.They're N.I.B.'s but the damm speaker spring posts do not make contact w/cable inserted in them/:crap:.The installer that tested them later said,'These were *USED* Ti's".These were the first Ti's my shop had gotten in.No 'Furbs/Etc. from Eclipse!!!!/:mad:.They have *Never* been installed or played.He did a bench test,was all on them. They do work,however,when power is applied to the *Tinsel Leads*.

I was told by a member,here,to switch out the *Binding Posts*,which is the culprits,and install & solder the leads onto the new binding posts.

I was at one time considering to sell them...and get the MTX/9512's DVC,4/Ohm Subs.I've heard they sound good as SQ subs,but I never heard them,so I don't know.

I think a ZR/1000 on each sub[bridged 4/Ohm Mono] wouldn't have a problem...

Are you looking for the newer style Ti's or the older Ti's,dadon? Take Care.

Regards/

Raymond

 
Price drop on this badboy... 250 shipped and its yours! I need this gone today or I will just keep it. 1500 watts for 250!!!!!! Clean power!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

dadon

10+ year member
CarAudio.com Elite
Thread starter
dadon
Joined
Location
missouri
Start date
Participants
Who Replied
Replies
31
Views
4,064
Last reply date
Last reply from
dadon
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top