2003 Chevy Impala
Head Unit: Clarion VRx765VD Cd/MP3, DVD, WMA, Ipod, Touch Screen
Front Speakers: (Components) Kenwood Excelon KFC-1700P
Rear Speakers: Stock
Front Speakers Amp: Hifonics Titan TXi6006 (150x2 @ 4ohms)
Subwoofers: (2) JL Audio 12W3 DVC2 (300w RMS each)
Subwoofer Amp: Hifonics Nemesis NX600
I've never quite understood how to do an installation with components. I've done several basic subwoofers installs and they were very simple, I guess because the sub is right back there with the amp.
My impala has a factory amp already, so I figure that the wires come out of my hu, run back to the factory amp (located in the trunk), then run to the speakers in the front doors and the 6x9's on the rear dead, is that correct?
I already have my components amp in the back, wired up (remote, power, ground, and rcas...the fuse isn't in up front). I have the wires for the speaker wires running back towards the front of the vehicle (on the right side), but is this incorrect? Should the I just cut the wires from the factory amp and tap into those?
Any help would be appreciated......diagrams would be appreciated even more.
