Imaging

Beerdrnkr
5,000+ posts

CarAudio.com Veteran
My setup is going to consists of 7" dayton mids in the doors, rainbow germs in kick panels (passenger kicks to driver seat, driver side kicks to passenger seat), focals in rear doors. I was wondering if I could put another set of the germ tweets in the factory tweeter pod on the pillar and if that would screw up my imaging or would it be pretty insignificant? I might not need to do this I bought a better amp for my germs and bought the daytons and still need to do a lot of sound deadening, this question is just for if I want it louder after I install everything. Could I also just use the factory tweeter pod and do a kick panel for the 6 1/2 mid and still have good imaging? Last question is would I be able to run an extra tweeter off of the same Germanium crossovers? Thanks

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Beerdrnkr

5,000+ posts
CarAudio.com Veteran
Thread starter
Beerdrnkr
Joined
Location
San Diego
Start date
Participants
Who Replied
Replies
0
Views
903
Last reply date
Last reply from
Beerdrnkr
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top