I added this brace to my port wall

  • 3
    Participant count
  • Participant list

Staynlean
10+ year member

Senior VIP Member
Pis is sideways obviously.

What do you guys think? I've seen some pretty intricate bracing before in many other boxes, does anybody believe this will effect output performance?

Box is for SA12.

2u42e6b.jpg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Does this harness have anything resembling an LOC? If not, I would guess that is the issue. I would test an inline passive LOC.
3
1K
Yeah, saw that too, was like ??? wtf! They do know there stuff, I usually just roll with it!
13
1K
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
3
847
While that program is pretty neat, it assumes you know the values. I was just recapping the numbers you provided. RS recommends the following...
4
1K
Whoa, that will be one skinny port. The width of the back wall ports will be 1.08" wide (27.5mm), but the front port will be shared by 2 subs so...
5
994

About this thread

Staynlean

10+ year member
Senior VIP Member
Thread starter
Staynlean
Joined
Location
Memphis, TN
Start date
Participants
Who Replied
Replies
3
Views
614
Last reply date
Last reply from
Staynlean
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top