Hyundai Elantra-4awg through firewall help!

[JLa Obsessed 10+ year member]

Trying to run 4awg wire through my friends Hyundai Elantra firewall...Cant seem to find any grommets or anything...anyone know any shortcuts? Thanks

Click to read more...

 

[NewAgeKing 5,000+ posts]

Use some ductape.

 

[SPL-Master 10+ year member]

i have a hyundai santa fe (i know different but what the hell) i had to take out the drivers inner finder liner and run the wire there and down through by the kick panel where there's a grommet

 

[JLa Obsessed 10+ year member]

Use some ductape.

thanks *** lol

 

[NewAgeKing 5,000+ posts]

thanks *** lol

Your welcome

 

[JLa Obsessed 10+ year member]

i have a hyundai santa fe (i know different but what the hell) i had to take out the drivers inner finder liner and run the wire there and down through by the kick panel where there's a grommet

could you explain that a little more clearly?

 

[SPL-Master 10+ year member]

ok well i could not find any grommets in the firewall so i had to route the wire through the drivers side fender because that's where all the rest of the electrical wires were located. so just take off the inner fender liner, its just a few screws, zip tie the wire up into the fender carefully. then take off the drivers side inner kick panel. in my car thats where the computer was and there was a big grommet in there which i was able to feed the wire from the fender to inside the car.

 

[Louisiana_CRX 5,000+ posts]

just drill a hole a little bigger than the wire then shine a flashlight through it...look on the other side till you see the light....then push the wire through...it is rare that you hit anything important drilling...if you do patch it with gorilla tape