How to remove Dynamat Extreme

[soul 10+ year member]

What would be the best way to remove Dynamat Extreme. I covered the entire trunk lid now I regret it.

Click to read more...

 

[jmanpc 5,000+ posts]

pull and hope for the best. lots of goo-gone.

 

[baseballer1100 5,000+ posts]

Would heat work?

 

[jmanpc 5,000+ posts]

maybe a putty knife

 

[Calikid 5,000+ posts]

its going to take a looooong time to get all of it off, why do u wont to take it off?

 

[bdawson72 5,000+ posts]

why do u want 2 take it all off

 

[T3mpest 10+ year member]

he doesnt' rattle and now people dont' think he "bumps"? Or maybe his car sounds quiter now that he doesnt' have all the extra rattles.

 

[dirtye30 10+ year member]

he managd to put it on u[pside down with 3m super 77

 

[enzowho 10+ year member]

If you want to take it off cause it looks like crap just cover it with some material (aka black closed cell foam, carpet, etc.) I put ensolite on my trunk lid and it looks good. I can pm you pic's if you want.

To do it, just grab some 3M spay and slowly work a whole piece on there. Grab a straight edge or long ruler and an utility knife and cut off the overlapping stuff.

 

[soul 10+ year member]

If you want to take it off cause it looks like crap just cover it with some material (aka black closed cell foam, carpet, etc.) I put ensolite on my trunk lid and it looks good. I can pm you pic's if you want.To do it, just grab some 3M spay and slowly work a whole piece on there. Grab a straight edge or long ruler and an utility knife and cut off the overlapping stuff.

I would like to see some pics maybe that will solve my problem. Send them to soulassasin84@yahoo.com

Thanks

 

[enzowho 10+ year member]

I would like to see some pics maybe that will solve my problem. Send them to soulassasin84@yahoo.com

Sure thing. I will send them to you tomorrow.

-rich

 

[enzowho 10+ year member]

The pic's were too big to email so I figured I would just link them here.

http://engr.oregonstate.edu/~lammersr/IMG_3418.jpg

http://engr.oregonstate.edu/~lammersr/IMG_3419.jpg

http://engr.oregonstate.edu/~lammersr/IMG_3420.jpg

The yellow spot on the left hand side is some "great stuff" that expanded. Tried to pick it off, but it just started riping the foam //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 

[Pop da Hatch 10+ year member]

Heat it with a Heat Gun and it will pull right off with the proper amount of heat. Start at the corner and work your way across.

/thread