IgnoreMe 5,000+ posts
CarAudio.com VIP
two quesions
1) so how exactly do i get from (talking about the top piece of the box)
to
???
i would think its just, make a rectangle on the top of the box and use the push/pull tool. but when i do it, the rectangle only applies to the internal parts of the box, and it pulls them up and out of the box, while the port sits there and basically makes a huge channel in my rectangle. not sure if you guys understand me of not.
2) how come, even though my walls are all perfect as far as dimensions go, but when i measure the width of the port, its 1/16" short? i mean, i didnt know a 27.5" piece on a 31.5" internal volume box created a 3 15/16" port width...
1) so how exactly do i get from (talking about the top piece of the box)
to
???
i would think its just, make a rectangle on the top of the box and use the push/pull tool. but when i do it, the rectangle only applies to the internal parts of the box, and it pulls them up and out of the box, while the port sits there and basically makes a huge channel in my rectangle. not sure if you guys understand me of not.
2) how come, even though my walls are all perfect as far as dimensions go, but when i measure the width of the port, its 1/16" short? i mean, i didnt know a 27.5" piece on a 31.5" internal volume box created a 3 15/16" port width...