how do i bridge 2 ap15001d's

[detroitdiesel 10+ year member]

I am going to run a lanzar opti 12" 1233D at 2.4 ohms, and am going to run it on two audiopipe ap15001d amps. I just need to know, how do i go about bridging these things? Thanks.

Click to read more...

 

[kr15 5,000+ posts]

you mean strapping them?

 

[detroitdiesel 10+ year member]

yes strapping.

Also, i just realized i posts in the wrong section. could a mod please move this post?

 

[phuck CA.com 10+ year member]

good question because I did it like the directions said that came with the amps and got almost no output, currently running just one 1500 and its MUCH louder

 

[KidThump 10+ year member]

If your using rca y splitters that is a common problem when using two amps.....

 

[phuck CA.com 10+ year member]

thats not how these amps strap. one set goes into one amp, then out to the other, that turns the 2nd amp into a slave, then you are supposed to connect both negatives on each amp together and then use the other + and - like normal, but when we did that it was a big fail, almost sounded like subs where out of phase, but after we just ran one amp it was much better

 

[KidThump 10+ year member]

Hmmmm, idk then

Just buy a 3k....

 

[phuck CA.com 10+ year member]

well we already have a pair of 1500s so trying to use them