How: Bridge orion 250hcca with a 2xs

[blackmax 10+ year member]

As title states does any know how to wire an Audiocontrol 2xs and a Orion 250hcca so that the orion is in bridged mode?

Click to read more...

 

[blackmax 10+ year member]

Anyone?

 

[gunz4me 10+ year member]

IIRC you need to use the inverted outs on the Audiocontrol to bridge the amp.

ETA: After that Orange will be your positive and Yellow will be your negative!

You could always pop the amp open and swap the + and - around on one of the channel's op amps to bridge a Generation 1 Orion amp too....

ETA2: I hope you have an old school 2XS because the newer ones don't offer the inverted output on the subwoofer side!

 

[Louisiana_CRX 5,000+ posts]

I always just used the Orion Bridging Modules...

 

[gunz4me 10+ year member]

This will do it too as well as allow you to put your subs in a small sealed enclosure:

Unfortunately it is NOT for sale!

 

[Louisiana_CRX 5,000+ posts]

I'd probably sell my Bridging module for the right amount of money...Its like new with manual and DIN Cable....

 

[Louisiana_CRX 5,000+ posts]

This will do it too as well as allow you to put your subs in a small sealed enclosure:

Unfortunately it is NOT for sale!

Willing to trade //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[gunz4me 10+ year member]

Willing to trade //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

I am planning on using it in my girlfriend's install in a couple of weeks. I might be open for trades if you are willing to deal with her wrath:laugh: