Hooking up atomic 3000.1

[maximpakt 10+ year member]

On my PA 3000.1 there is only 1 set of speaker outputs. So I connected my 2 dual 4 ohm L7's for the amp to see one ohm output. On the other set I wired the subs the same way, but when I got to the atomic connections I see it has 2 speaker outs instead of one. So two speaker outs and one wire to the subs, where in the hell does it go?.

Click to read more...

 

[loudaccent 10+ year member]

take a pic of the side of the amp were the connectioons are being made

 

[maximpakt 10+ year member]

Ok, I found a manual for a smaller atomic amp. Apparently if I understand it right there is not a way to use one out on this thing. I need to run seperate runs to my speakers. Is it just me or does a monoblock amp with two outputs sound wrong, I thought the whole meaning of mono was one? Well ill go hook it up the way the other manual shows. Will report back later.

 

[audioarsonal 10+ year member]

There are quit a few mono amps with dual speaker outputs.The output from them is still mono they just provide with more places to input the speaker wire.Instead of trying to cram 2 runs of 8ga into one set(what a *****!)

 

[Seven71ne 10+ year member]

my 500.1 is like that, but it says underneath the inputs that there wired parallel.

 

[maximpakt 10+ year member]

Well, a lot of wiring and we did some preliminary testing. Everything works. Now just gotta make it pretty and tweak it all.