Hi

[ThirdGenHemi]

hey guys, im new to the forum, and live in orlando. im getting ready to put a sundown audio sa-10 and rockford fosgate p600 in my charger. any advice on ported enclosures for this sub would be greatly appreciated.

thanks

jonathan

Click to read more...

 

[subzero 5,000+ posts]

1.25 - 1.5 cubic feet tuned to 30 - 35 Hz

Slot port or aero port.

 

---------- Post added at 01:53 AM ---------- Previous post was at 01:52 AM ----------

 

welcome to the site. what are your audio goals and experience in the hobby?

 

[ThirdGenHemi]

thanks for the advice. that sounds good. do you have any recommendations on the port area and length. im having trouble with the WinISD software...

 

[subzero 5,000+ posts]

check your other thread

 

[ThirdGenHemi]

1.25 - 1.5 cubic feet tuned to 30 - 35 Hz Slot port or aero port.

 

---------- Post added at 01:53 AM ---------- Previous post was at 01:52 AM ----------

 

welcome to the site. what are your audio goals and experience in the hobby?

my experience, my last set up was a 15in L7 in a 6 cuft box with about 1000rms going to it. i built the box to competition specs supplied by kicker(they made it easy, it was in the back of the users manual)... but im new to using box building/tuning software. i had plenty of highs as well if you guys want to hear about that too.

my goals, im trying to stay simple with this build. i dont want to go too over the top with multiple amps, component speakers, batteries and wires everywhere etc this time. im trying to keep trunk room and a relatively factory appearance. i figure a sa-10 in a, give or take, 1.25 cubic foot ported box with 600 rms going to it with the factory alpine system supplying the highs should be fine.

thanks again for the kind welcome and advice

 

[brooklynjoy2008 10+ year member]

Welcome to the forum, and I'm sure plenty of people have advice for you. You know what you want to run I'm sure someone can help you.